Home > Knowledge > Content
Home application surface protective film cleaning program
- Oct 27, 2018 -

1. This situation is that the film is not fragmented. The home application surface protective film needs to be cut around with a knife first (usually the film is directly processed on the film, this step is to prevent the edge from being unclean, the edge can be removed if it is removed), and then the corner is buckled with a fingernail. It’s just going out. The membrane may have two layers inside and outside, which mainly makes the inner membrane difficult, and the surface to be pulled is large to reduce the fracture. Slow speed, synchronous advancement (I exposed two corners and then pulled down at the center line)

2. If the film is relatively brittle, if it is thin, it can be like this. Generally, the film outside is not there, so we will put it on the outside and use it with latex. Apply a layer of brush, and the strength is very high after drying. Then use the method of 1 to operate.

3. This is what happened when I first started experimenting. I used a coin to scrape the surface of the film to help the penetration of the sol. I thought that the product was not strong. After scraping the flower, I cleaned the other side and found my bottle of glue. The agent was attached with a small plastic shovel (really small, the shovel surface also the width of the nail) and then shovel the film with a force of about 45 degrees. Because the plastic has low hardness, there is no scratch. If you don't have this thing, you can go straight to the thumb and push or hang with your fingernails, but there will be a lot of residual glue, and it is best to get the glue. If you feel that it is not broken enough, try to scrape a few more coins and mind the first test of scratches. Afterwards, you can cover up some traces with glazing wax. Also use the method of 1 to draw it around.

https://www.kingrealfilm.com/